Horizontal Lathe-C61100
Introduction
This lathe is designed to mainly perform turning. It can turn face, outside diameter and hole of various workpieces, can cut metric and inch threads, module threads and DP threads. Short tapers can be turned by using upper slide independently and long tapers by using upper slide together with longitudinal feed. Hole drilling and boring is possible. It can cut two workpieces in one pass with an annular borer. Power, speed and rigidity of the lathe greatly meet the needs of rough and finish turning. It can also be applied to forced cutting with hardened alloy tools, to cutting various nonferrous and ferrous metals.
Specifications
Item Specification
Max. Swing over bed φ 1000mm
Over slide φ 630mm
Max. Workpiece length Max. Distance between centers 1500mm 3000mm
Max. Workpiece turning length 1300mm 2800mm
Bed and spindle Length of bed 4200mm 5700mm
Width of bed way 755mm
Spindle nose A15
Taper of spindle front 140# Metric taper
Spindle thru-hole φ 130mm
Taper of center MT No. 6
Front bearing of spindle φ 200mm
Middle bearing of spindle φ 180mm
Rear bearing of spindle φ 160mm
Tailstock Diameter of quill φ 160mm
Taper hole of quill MT No. 6
Effective travel of quill 300mm
Width of tailstock way 460mm
Tool post Max. Permissible tool section 45mm× 45mm
Swivel angle of mid slide ± 90°
Max. Travel of upper slide 300mm
Max. Travel of lower slide 520mm
Motion Step of spindle speed 21 steps
Range of spindle speed 3.15~315r/min
Feed Longitudinal and cross feed 56 kinds each
Range of feed Cross feed 0.05~6mm/r
Longitudinal feed 0.1~12mm/r
Diameter and pitch of lead screw Diameter φ 70 mm
Pitch 12 mm
Range of threading Kinds of metric threads 44 kinds
Range of metric threads 1~120mm
Kinds of inch threads 42
Range of inch threads 30~1/4tpi
Kinds of module threads 45 kinds
Range of module threads 0.5~60πmm
Kinds of DP threads 47 kinds
Range of DP threads 60~0.5DP
Drive Power source 3-phase AC power
Main motor Y180L-4
Power of main motor 22kW
Speed of main motor 1450 r/min
Rapid traverse motor YS90S-2
Power of rapid traverse motor 1.5 kW
Speed of rapid traverse motor 2800 r/min
Coolant pump AYB-25
Power of coolant pump 0.12 kW
Flow of coolant pump 25L/min
Operation and lubrication Gear pump HY01-12× 20
Pressure of gear pump 2MPa
Flow of gear pump 12L/min
Speed of gear pump 1450 r/min
Working pressure of oil cylinder 1~1.5 MPa
Dimension and weight Height 1700mm
Length 4600mm 6100mm
Width 1400mm
Net weight 9200kg 10700kg
Audited Supplier 
){kind=link}